SMC Networks SMC9452TX Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Sítě SMC Networks SMC9452TX. SMC Networks SMC9452TX User's Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 62
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
EZ Card 1000
1000 Mbps Gigabit Ethernet
PCI Network Card
High performance for instant access to network resources
Delivers 2 Gbps of bandwidth over installed
Category 5 UTP
Support for 32-bit PCI bus up to 66 MHz
Full- and half-duplex operation at 1000, 100, and
10 Mbps
IP, TCP and UDP checksum off-loading capability to reduce
CPU overhead
User Guide
SMC9452TX
Zobrazit stránku 0
1 2 3 4 5 6 ... 61 62

Shrnutí obsahu

Strany 1 - EZ Card 1000

EZ Card 10001000 Mbps Gigabit Ethernet PCI Network CardHigh performance for instant access to network resourcesDelivers 2 Gbps of bandwidth over insta

Strany 2

COMPLIANCESvi

Strany 3 - User Guide

viiTABLE OF CONTENTS1 Installing The Network Card . . . . . . . . . . . . . . . 1-1Introduction . . . . . . . . . . . . . . . . . . . . . . . . .

Strany 4

viiiOffload Checksum . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-2Packet Size (Maximum) . . . . . . . . . . . . . . . . . . . . . . .

Strany 5 - Limited Warranty

1-1CHAPTER 1INSTALLING THE NETWORK CARDIntroductionSMC’s EZ Card 1000, SMC9452TX, is a Gigabit Ethernet network interface card for 32-bit PCI local bu

Strany 6

INSTALLING THE NETWORK CARD1-2Hardware DescriptionThe EZ Card 1000 is a Gigabit Ethernet network card designed for 32-bit PCI-bus computers. The card

Strany 7

INSTALLING THE NETWORK CARD1-3LED IndicatorsThe EZ Card 1000 network card includes status LED indicators as described in the following figure and tabl

Strany 8

INSTALLING THE NETWORK CARD1-4Package ContentsAfter unpacking the EZ Card 1000, check the contents of the box to be sure you have received the followi

Strany 9 - Japan VCCI Class B

INSTALLING THE NETWORK CARD1-5System RequirementsBefore you install the EZ Card 1000, check your system for the following requirements:◆ A PC and BIOS

Strany 10 - OMPLIANCES

INSTALLING THE NETWORK CARD1-6• When using a 32-bit PCI slot, the end of the card’s edge connector will be exposed. Be careful that it does not touch

Strany 11

INSTALLING THE NETWORK CARD1-74. Replace the chassis cover on your PC and power it on. 5. The EZ Card 1000 should be automatically configured by the h

Strany 13 - NSTALLING

INSTALLING THE NETWORK CARD1-8Connecting Category 5 CableTo connect to a 1000BASE-T Gigabit Ethernet device, use the RJ-45 connector on the network ca

Strany 14 - RJ-45 Connector

INSTALLING THE NETWORK CARD1-9Connecting UTP Cable1. Attach the male RJ-45 connector on one end of a UTP cable to the network card’s RJ-45 port.Figure

Strany 15 - Figure 1-2. Status LEDs

INSTALLING THE NETWORK CARD1-10

Strany 16

2-1CHAPTER 2INSTALLING AND CONFIGURINGNETWORK DRIVERSWindows NT 4.0 InstallationCaution: Prior to installing the driver, make sure you have upgraded t

Strany 17 - Inserting the Network Card

INSTALLING AND CONFIGURING NETWORK DRIVERS2-24. When prompted to “Select a Network Adapter,” click on “Have Disk.” Insert the SuperDisk when prompted

Strany 18 - 32-Bit PCI Slot

INSTALLING AND CONFIGURING NETWORK DRIVERS2-3Secondary InstallationFollow this procedure if you have already installed another network card or loaded

Strany 19 - PCI Configuration

INSTALLING AND CONFIGURING NETWORK DRIVERS2-4Further ConfigurationYou can modify card settings, install additional protocols and other network compone

Strany 20 - Connecting Category 5 Cable

INSTALLING AND CONFIGURING NETWORK DRIVERS2-5Windows 2000 InstallationThe EZ Card 1000 driver for Windows 2000 conforms to the Network Driver Interfac

Strany 21 - RJ-45 Port

INSTALLING AND CONFIGURING NETWORK DRIVERS2-6Novell NetWare InstallationNetWare Server 5.0Installing the LAN driver is part of the NetWare installatio

Strany 22

INSTALLING AND CONFIGURING NETWORK DRIVERS2-78. A screen with three dialog boxes is displayed. To change the driver configuration, tab to the “SMC9452

Strany 23 - Windows NT 4.0 Installation

6 HughesIrvine, CA 92618Phone: (949) 707-2400EZ Card 1000User GuideFrom SMC’s EZ line of low-cost workgroup LAN solutionsJune 2001Pub. # 150000003500A

Strany 24 - ONFIGURING

INSTALLING AND CONFIGURING NETWORK DRIVERS2-8NetWare Server 4.11Installing the LAN driver is part of the NetWare installation process. Use the followi

Strany 25

INSTALLING AND CONFIGURING NETWORK DRIVERS2-99. A screen with three dialog boxes is displayed. To change the driver configuration, tab to the “SMC9452

Strany 26

INSTALLING AND CONFIGURING NETWORK DRIVERS2-10Linux 2.2.X or Later InstallationThis section describes the procedure for manual and automatic loading a

Strany 27 - Windows 2000 Installation

INSTALLING AND CONFIGURING NETWORK DRIVERS2-11RxBufSize: This is the size of the receive buffer memory space allocated per receive descriptor (the lab

Strany 28 - Novell NetWare Installation

INSTALLING AND CONFIGURING NETWORK DRIVERS2-12BOOTPROTO=noneBROADCAST=207.200.5.255NETWORK=207.200.5.0NETMASK=255.255.255.0IPADDR=207.200.5.2Automatic

Strany 29

INSTALLING AND CONFIGURING NETWORK DRIVERS2-13where “ethx” will be “eth0” if you do not have any other adapters, “eth1” if you already have one, and s

Strany 30

INSTALLING AND CONFIGURING NETWORK DRIVERS2-14Windows 98 InstallationThe EZ Card 1000 driver for Windows 98 conforms to the Network Driver Interface S

Strany 31

INSTALLING AND CONFIGURING NETWORK DRIVERS2-15“C:\WINDOWS\SYSTEM” directory and the “SMC9452.INF” file from “A:\Win98” to the “C:\WINDOWS\INF” directo

Strany 32

INSTALLING AND CONFIGURING NETWORK DRIVERS2-16Other InstallationsRefer to the installation documents on SMC’s SuperDisk for instructions on installing

Strany 33

3-1CHAPTER 3CONFIGURING THENETWORK CARDConfigurationThis section describes the configuration procedure in a Windows environment. When you install the

Strany 34

Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, n

Strany 35 - # reboot

CONFIGURING THE NETWORK CARD3-2Media TypeIn this field auto-negotiation can be enabled, or the card’s link speed and duplex mode can be selected. If a

Strany 36 - Windows 98 Installation

CONFIGURING THE NETWORK CARD3-3Pause ControlPause frames are used to control network congestion. In this field the card may be configured to transmit

Strany 37

CONFIGURING THE NETWORK CARD3-4Using VLANsThe TigerCard 1000 network card supports the IEEE 802.1Q VLAN standard and can be configured to participate

Strany 38 - Latest Drivers

A-1APPENDIX ATROUBLESHOOTINGPCI CompatibilityEarly PCI BIOS versions do not properly support the PCI specification and may “hang” when a network card

Strany 39

TROUBLESHOOTINGA-2◆ Make sure the PCI slot is configured to support INTA.◆ Ensure that INTA for the slot is assigned to a free interrupt (IRQ) number.

Strany 40

TROUBLESHOOTINGA-3Solutions for Common ProblemsProblems are often caused by cabling errors, conflicts with other devices installed in the same compute

Strany 41

TROUBLESHOOTINGA-4Network Connection ProblemsIf your computer cannot find the EZ Card 1000 card, or the network driver does not install correctly, che

Strany 42 - Traffic Priority

B-1APPENDIX BCABLESCable Specifications Cable Types and SpecificationsCable Type Max. Length Connector10BASE-T Cat. 3, 4, 5 100-ohm UTP 100 m (328 ft)

Strany 43 - ROUBLESHOOTING

CABLESB-2Twisted-Pair Cable and Pin AssignmentsCaution: DO NOT plug a phone jack connector into any RJ-45 port. Use only twisted-pair cables with RJ-4

Strany 44

CABLESB-31000BASE-T Pin Assignments1000BASE-T ports support automatic MDI/MDI-X operation, so you can use straight-through cables for all network con

Strany 45 - Solutions for Common Problems

iLimited WarrantyLimited Warranty Statement: SMC Networks, Inc. (“SMC”) warrants its products to be free from defects in workmanship and materials, un

Strany 47 - Cable Specifications

C-1APPENDIX CSPECIFICATIONSBus Interface32-bit bus master, PCI33 MHz and 66 MHzInterruptINTANetwork Interface1000BASE-T: UTP cable; Category 5, 5e or

Strany 48

SPECIFICATIONSC-2Operating Voltage+5 VDC @ 2.7 A maximumSize (without bracket)7.9 x 16.5 cm (3.11 x 6.50 in.)Weight80g (2.8 oz)TemperatureOperating 0

Strany 49 - 1000BASE-T Pin Assignments

SPECIFICATIONSC-3Software DriversODI Drivers NetWare Server 4.1x or laterNDIS Drivers Windows NT 4.0Windows 95Windows 98Windows MEWindows 2000Unix Dri

Strany 50

SPECIFICATIONSC-4

Strany 51 - PECIFICATIONS

Glossary-1GLOSSARY10BASE-TIEEE 802.3 specification for 10 Mbps Ethernet over two pairs of Category 3, 4, or 5 UTP cable.100BASE-TXIEEE 802.3u specific

Strany 52

GLOSSARYGlossary-2End StationA workstation, server, switch, bridge or router.EthernetA network communication system developed and standardized by DEC,

Strany 53 - Software Drivers

GLOSSARYGlossary-3IEEE 802.3Defines carrier sense multiple access with collision detection (CSMA/CD) access method and physical layer specifications.

Strany 54

GLOSSARYGlossary-4Network DiameterWire distance between two end stations in the same collision domain.Switched PortsPorts that are on separate collisi

Strany 55 - Glossary-1

Index-1Aauto-negotiation 2-2BBIOS requirements 1-5, A-1bus-mastering 1-5, A-1Ccableadjusting Category 5 cable 1-8guidelines 1-7specifications B-1card

Strany 56 - Glossary-2

LIMITED WARRANTYiiWARRANTIES EXCLUSIVE: IF AN SMC PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, CUSTOMER'S SOLE REMEDY SHALL BE REPAIR OR REPLACEM

Strany 57 - Glossary-3

INDEXIndex-2PCIbus specification 1-5compatibility A-1configuration 1-7pin assignments B-2RRELEASE.TXT file 1-7requirements of system 1-5RJ-45 connecto

Strany 59

6 HughesIrvine, CA 92618Phone: (949) 707-2400FOR TECHNICAL SUPPORT, CALL:From U.S.A. and Canada (24 hours, 7 days a week)(800) SMC-4-YOU; (949) 707-24

Strany 60

iiiCOMPLIANCESFCC - Class BThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

Strany 61

COMPLIANCESivEC Conformance Declaration - Class BSMC contact for these products in Europe is:SMC Networks Europe,Edificio Conata II, Calle Fructuós Ge

Strany 62

COMPLIANCESvIndustry Canada - Class BThis digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set

Komentáře k této Příručce

Žádné komentáře