Smc-networks TIGERSWITCH 10/100 Uživatelský manuál stáhnout pdf (Strana 82)

ONFIGURING

THE

WITCH

2-50

• Path Cost – This parameter is used by the STP to determine the

best path between devices. Therefore, lower values should be

assigned to ports attached to faster media, and higher values

assigned to ports with slower media. (Path cost takes

precedence over port priority.)

- Full Range: 1-65535

- Recommended Range –

- Ethernet: 50-600

- Fast Ethernet: 10-6

- Gigabit Ethernet: 3-10

- Defaults –

- Ethernet – half duplex: 100; full duplex: 95; trunk: 90

- Fast Ethernet – half duplex: 19; full duplex: 18; trunk: 15

- Gigabit Ethernet – full duplex: 4; trunk: 3

• Fast Forwarding – You can enable this option if an interface

is attached to a LAN segment that is at the end of a bridged LAN

or to an end node. Since end-nodes cannot cause forwarding

loops, they can pass directly through to the forwarding state.

Fast Forwarding can achieve quicker convergence for

end-node workstations and servers, and also overcome other

STA related timeout problems. (Remember that Fast

Forwarding should only be enabled for ports connected to an

end-node device.)

- Default: disabled

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 317 318

Žádné komentáře

Smc-networks TIGERSWITCH 10/100 Uživatelský manuál Strana 82