Smc-networks ElliteConnect 2.4GHz/5GHz Uživatelský manuál stáhnout pdf (Strana 117)

Advanced Configuration

6-41

The wireless bridge acts as an SNTP client, periodically sending

time synchronization requests to specific time servers. You can

configure up to two time server IP addresses. The wireless bridge

will attempt to poll each server in the configured sequence.

SNTP Server – Configures the wireless bridge to operate as an

SNTP client. When enabled, at least one time server IP address

must be specified.

• Primary Server: The IP address of an SNTP or NTP time

server that the wireless bridge attempts to poll for a time

update.

• Secondary Server: The IP address of a secondary SNTP or

NTP time server. The wireless bridge first attempts to update

the time from the primary server; if this fails it attempts an

update from the secondary server.

Note: The wireless bridge also allows you to disable SNTP and set the

system clock manually using the CLI.

Set Time Zone – SNTP uses Coordinated Universal Time (or

UTC, formerly Greenwich Mean Time, or GMT) based on the time

at the Earth’s prime meridian, zero degrees longitude. To display

a time corresponding to your local time, you must indicate the

number of hours your time zone is located before (east) or after

(west) UTC.

Enable Daylight Saving – The wireless bridge provides a way to

automatically adjust the system clock for Daylight Savings Time

changes. To use this feature you must define the month and date

to begin and to end the change from standard time. During this

period the system clock is set back by one hour.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 321 322

Žádné komentáře

Smc-networks ElliteConnect 2.4GHz/5GHz Uživatelský manuál Strana 117