SMC Networks TigerSwitch Uživatelský manuál stáhnout pdf (Strana 40)

100

101

NITIAL

ONFIGURATION

2-4

For a description of how to use the CLI, see “Using the Command Line

Interface” on page 4-1. For a list of all the CLI commands and detailed

information on using the CLI, refer to “Command Groups” on page 4-12.

Remote Connections

Prior to accessing the switch’s onboard agent via a network connection,

you must first configure it with a valid IP address, subnet mask, and default

gateway using a console connection, DHCP or BOOTP protocol.

The IP address for this switch is obtained via DHCP by default. To

manually configure this address or enable dynamic address assignment via

DHCP or BOOTP, see “Setting an IP Address” on page 2-8.

Note: This switch supports four concurrent Telnet/SSH sessions.

After configuring the switch’s IP parameters, you can access the onboard

configuration program from anywhere within the attached network. The

onboard configuration program can be accessed using Telnet from any

computer attached to the network. The switch can also be managed by any

computer using a web browser (Internet Explorer 5.0 or above, or

Netscape Navigator 6.2 or above), or from a network computer using

SNMP network management software.

Note: The onboard program only provides access to basic configuration

functions. To access the full range of SNMP management

functions, you must use SNMP-based network management

software.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 517 518

Komentáře k této Příručce

Žádné komentáře

SMC Networks TigerSwitch Uživatelský manuál Strana 40

Komentáře k této Příručce

Související produkty a manuály pro Síťové přepínače SMC Networks TigerSwitch